7'10" Jive Space Elevator surfgear The rail foil starts turned

The rail foil starts turned up in the nose

The bottom contour of the board consists of a slight roll in the nose that move to a subtle single concave that run the remainder of the board

The rails are fuller than those of the Disco and a sharp edge travels half way up the board

Holds approximately 30oz

The bottom contour starts with a slight single concave in the nose that runs into a triplane hull that runs into 3 tight channels that run the middle of the board out the tail

7'10" Jive Space Elevator surfgear The rail foil starts turned7'10" x 21 3 4" x 3" Jacob Ells is a Santa Barbara based shaper who is always looking to push the boundaries of alternative boards. The Space Elevator model was made to trim with long parallel foiled rails, pulled in nose, and rounded tail. The rocker of the board is low allowing for high down the line speed. The bottom contour is quite interesting starting flat in the nose and quickly turning into a tri plane hull with a deep single concave that runs